Archive for Wc3 clan about the custom game Island Troll Tribes
  Forum Index -> Questions about ITT mechanics

Long-term storage of construction machinery and post-mainten

<P>Pump piston because of direct contact with the concrete, requiring sealing, wear, when we found the water tank in the water or muddy concrete, we should realize that the piston is serious wear and tear,road block newport news we need to check the piston, If the piston wear and tear on the need for timely replacement, so as not to hurt the concrete cylinder. Specific steps are as follows:</P>
<h3>First, ready to work</h3>
<P>The water in the tank to put the net, clean up the debris inside the tank.</P>
<h3>Second, the demolition steps</h3>
<P>1, remove the limit sets and pressure plate, the end of the U-valve closed, rotating to the cylinder and vertical.2, the panel selection surface control,road crack pit repair machine through the manual jog, the piston back to the tank inside.3, followed by the hexagonal and crescent wrench on the demolition of the piston (usually have these tools on the car, pay attention to the demolition must stop, press the emergency stop).4, after the completion of the demolition of a rope or other tools to take out the piston body, demolition is completed.</P>
<h3>Third, the installation steps</h3>
<P>1, in order to facilitate the installation, the installation of the piston before the grease, or with the rope to the piston inside the tank. Make the cylinder connection flange and piston flange right.2,paving equipment for sale used a little bit about the cylinder, you want to replace the piston into a small part of the concrete inside the cylinder, the use of crescent wrench on the flange connection screw alignment.</P> Forum Index -> Questions about ITT mechanics
Page 1 of 1
Create your own free forum | Buy a domain to use with your forum